I almost drove over to Home Depot the night before PPM this year to buy a small screwdriver (ouch) and a few screws, but decided since I had never done it, this would be a bad time to try for the first time.
The magnetic screw driving bits make the job a lot faster and easier, I go this set a few years ago and it was a huge help. I like the guerilla glue idea too, i'll have to give that a shot (I have tried red loctite with little success though).
I have also learned to not over tighten the screw with the drill. I use the drill to get all the screws most of the way in, then use a socket to snug them up by hand to prevent stripping out the hole.
For maintenence, I also make sure they are snug with the hand socket after every run.
Cool video.
ReplyDeleteI almost drove over to Home Depot the night before PPM this year to buy a small screwdriver (ouch) and a few screws, but decided since I had never done it, this would be a bad time to try for the first time.
Plus I didn't want Popeye forearms.
Thanks for posting this. I actually picked up some screws today 3/8". So I am going to do this tonight.
ReplyDeleteGeorge, check these out....
ReplyDeletehttp://www.lowes.com/lowes/lkn?action=productDetail&productId=175465-70-DW2235IR&lpage=none
The magnetic screw driving bits make the job a lot faster and easier, I go this set a few years ago and it was a huge help. I like the guerilla glue idea too, i'll have to give that a shot (I have tried red loctite with little success though).
I have also learned to not over tighten the screw with the drill. I use the drill to get all the screws most of the way in, then use a socket to snug them up by hand to prevent stripping out the hole.
For maintenence, I also make sure they are snug with the hand socket after every run.